How to raise power for wireless
card TP-LINK 951 V3 to 600mw
1- Remove 2 resistor r55 and r41
2- Insert capictor 10mf 16v Parallel with C86
3- Insert capictor 1nf Instead of capictor C378
Subscribe to:
Post Comments (Atom)
Popular Posts
-
1-download putty from here download 2-open putty 1-your ubnt ip 2-port 3-open 3- Enter your ubnt user (ubtn) and password 4- wr... -
How to convert tp-link access to ubiquiti rocket m2 model's to convert wa701v1 wa801v1 mr3220v1 mr3420v1 wa730v1 wa830v1 wa901v1 wr74...
-
Updating the firmware on Nanostation 5 using serial port and ethernet port The video has arabic commentry, but it should be good enough to... -
Flashing Nanostation 5 from Windows 7 using Serial Port to put in Recovery Mode and tftp over Ethernet cable to flash the firmware. Va... -
This super simple circuit design of a gsm car security system really works. Don't believe it? Find out and learn the simple method of co...
-
Materials Light dependent resistor (LDR) 1k resistor PNP transistor 3 volt battery Bright LED Marker or other enclosure Step 1 ...
-
Take the lens out of the webcam and turn it around to allow it to focus very close. Have a look at the last picture, that is...
-
How to raise power for access point DWL-3200AP to 1000mw 1- Replace red resistor with bridge 2- Replace blue resistor with r... -
How to raise power for wireless access TP-LINK 801 V1 to 32db Remove resistor R171 only
No comments:
Post a Comment